Monday, October 18, 2010

Planning to Build a Reuel Parker Periagua 14

I've decided on Reuel Parker's unique Periagua 14 for the dinghy that I'll be using aboard my Tiki 26 catamaran when I launch it next year.  With an overall beam of 15 feet, I can accommodate a long, slender craft like the Periagua 14 on the forward deck area, without the ends hanging off the sides (although after discussing it with Reuel, I may shorten it by a foot or two).  I want something long and canoe or kayak-like, that is easy to row, but with good load-carrying ability and room for two or three passengers in dinghy service.  I have Bolger Nymph that I built for the monohull I had previously, and it's a great dinghy, but something longer and sleeker is more to my liking.  Here are some photos from Reuel Parker:



In the photo below, you can see the pronounced rocker, the flare in the hullsides, and the pram bow.  It's like a stretched pram in some ways, but also brings to mind the sharpie hull form, which is favorite of Reuel Parker, who is after all, the author of The Sharpie Book.  This boat is very similar to my own Backwoods Drifter design, except that the Drifter is wider in the bottom and has a flat run amidships with no rocker.  The Periagua 14 is a pure rowing craft, though Reuel says that he has modified his to accept a small outboard at times. 


Although it is long, this is a lightweight boat, weighing in at approximately 65 pounds, depending on materials used.  Here is Reuel Parker's description of the design:

PARKER MARINE ENTERPRISES


PERIAGUA 14

LOA                      14’

BEAM                   3’ 6 ½”

DRAFT                  4 ¼”

WEIGHT               65 lbs (approx)


The PERIAGUA 14 is derived from the drawings in Chapman’s Architectura Navalis. The type was used as a lighter and ferry on rivers and in harbors in Sweden in the 18th century. She looks like a long, narrow pram, and is surprisingly fast, maneuverable and easy to row. Despite her narrow beam, she has much better stability than the DORY 14 on the previous page.

Like the DORY 14, she is built around bulkheads (or frames) and transom, for which patterns are supplied. The bottom and sides are drawn to scale with measurements supplied--all that is necessary is to transfer the measurements to full-size plywood sheets (no lofting required). She may be built lapstrake if preferred.

The PERIAGUA 14 also has only one solid wood component--the sheer clamp. It is made by ripping a slot in the bottom of a hardwood 1x2, which in turn slides over the plywood sheer.

"I built the prototype in my barn in Maine in less than 10 hours, ready for sanding and painting. Mine has only one pair of rowing tholes, while the plans show two. These were originally made from grown knees—mine are plywood, and they work fantastically well (I think of them as “out-riggers”—like those used on sculls). However, they are also quite awkward, and I ended up cutting them down and installing right-angle-fitting bronze rowlock sockets."

David Halladay also built a Periagua 14 as a tender to his Tiki 30, Abaco. Here are some photos of his under construction and on the deck of the catamaran:






No comments:

Post a Comment

"A boat is freedom, not just a way to reach a goal."
Bernard Moitessier - A Sea Vagabond's World

LinkWithin

Related Posts Plugin for WordPress, Blogger...